Charging The Battery Using A Battery Charger - PEUGEOT 208 Handbook

Starting using another
battery
Connect the red cable to the positive
terminal (+) of the flat battery A , then to the
positive terminal (+) of the slave battery B .
Connect one end of the green or black
cable to the negative terminal (-) of the
slave battery B.
Connect the other end of the green or black
cable to the earth point C on your vehicle
(engine mounting).
Operate the starter, let the engine run.
Wait until the engine returns to idle and
disconnect the cables.
Practical information
Charging the battery using
a battery charger
Disconnect the battery from the vehicle.
Follow the instructions for use provided by
the manufacturer of the charger.
Connect the battery starting with the
negative terminal (-).
Check that the terminals and connectors
are clean. If they are covered with sulphate
(whitish or greenish deposit), remove them
and clean them.
The Stop & Start battery does not have
to be disconnected for charging.
7
175