Download Print this page

Charging Battery Using Battery Charger - PEUGEOT 308 Handbook

Hide thumbs
Also See for 308 
Handbook - 400 pages
Manual - 292 pages
Handbook - 20 pages

Advertisement

Table of Contents
Starting using another battery
Connect the red cable to the positive
terminal (+) of the fl at battery A ,
then to the positive terminal (+) of
the slave battery B .
Connect one end of the green
or black cable to the negative
terminal (-) of the slave battery B .
Connect the other end of the green
or black cable to the earth point C
on the broken down vehicle.
Operate the starter, let the engine run.
Wait until the engine returns to idle
and disconnect the cables.
Charging the battery using a
battery charger
i
The Stop & Start battery does not
have to be disconnected for charging.
Disconnect the battery from the
vehicle.
Follow
the
instructions
provided by the manufacturer of the
charger.
Reconnect starting with the negative
terminal (-).
Check
that
the
terminals
connectors are clean. If they are
covered with sulphate (whitish or
greenish deposit), remove them and
clean them.
PRACTICAL INFORMATION
The batteries contain harmful sub-
stances such as sulphuric acid and
lead. They must be disposed of in
accordance with regulations and
must not, in any circumstances, be
discarded with household waste.
Take used remote control batteries
and vehicle batteries to a special
collection point.
for
use
i
It is advisable to disconnect the
battery if the vehicle is to be left un-
used for more than one month.
and
!
Do not disconnect the terminals
while the engine is running.
Do not charge the batteries without
disconnecting the terminals fi rst.
Do not push the vehicle to start the
engine if it is fi tted with the 6-speed
electronic gearbox system.
11
205

Hide quick links:

Advertisement

Table of Contents
loading

  Also See for PEUGEOT 308