Solenoid Valve, How To Replace - Nu-Vu OP-2FM Owner's Manual

OP–2FM OWNER'S MANUAL
Fig. #15 – AUTOMIST COMPONENTS
D. Insert the mounting screw through the center of the replacement Repeat Cycle Timer and fasten
the Timer to the mounting bracket. Do not overtighten the mounting screw or you may crack the
Timer's plastic case.
E. Reconnect all electrical wiring as it is tagged. All connections must be clean and tight.
F. Replace the Control Access Panel. Be careful not to pull or pinch any wires when replacing the
panel.
G. Restore electrical power to the unit and test the Repeat Cycle Timer and Humidity Control [81]
for proper operation.

SOLENOID VALVE, How To Replace:

MAKE SURE ALL POWER TO THE UNIT IS OFF. FAILURE TO DO SO MAY CAUSE
SEVERE EQUIPMENT DAMAGE OR PERSONAL INJURY!
A. Locate and turn OFF the main water supply to the Proofer.
B. Remove the Side Access Panel [76] from the Hinge side of your unit.
C. The Solenoid Valve [84] is an odd-shaped red, green and brass plumbing fixture mounted on the
base of the unit. Label and disconnect the electrical wiring to the Solenoid Valve.
D. Loosen the copper tubing connections to the Solenoid Valve body and remove the plumbing from
the Solenoid Valve.
NOTE: Place a towel or other absorbent material under the Solenoid Valve to catch any
water that may drain from the disconnected tubing. Protect all electrical components in
the work area from water.
E. Remove the Solenoid Valve mounting screws and remove the Solenoid Valve from the Proofer.
IMPORTANT: Make note of the flow direction before removing the Solenoid Valve.
F. Position the replacement Solenoid Valve in the Proofer and secure it into place. Make sure the
flow direction as marked on the Solenoid Valve body is the same as that observed in step "E".
NU–VU® FOOD SERVICE SYSTEMS
(800) 338-9886
PO BOX 35
SALES FAX (906) 863-5889 • SERVICE FAX (906) 863-6322
SERVICE AND REPLACEMENT GUIDE
MENOMINEE, MICHIGAN 49858-0035
page 37