Caster, How To Replace; To Raise Unit Off The Floor - Nu-Vu OP-2FM Owner's Manual

OP–2FM OWNER'S MANUAL
IMPORTANT: DO NOT STRETCH OR PULL ON THE GASKET DURING
INSTALLATION. THIS WILL LATER CAUSE THE TRIMMED CORNERS TO
SEPARATE AND PULL APART!
E. Use a sharp knife or a single-edged razor blade to cut the ends of the Gasket at a 45 angle (you
can use the mitered corner joint on the Door as an angle guide). Cut the Gasket about ¼" longer
than the required length and work the excess back into the slot. This extra Gasket will help to
create a nice tight corner joint, and allows for any follow-up trimming that may be necessary.
F. Work your way around the entire Door (or the section of the Door having the Gasket replaced).
Make sure the Gasket is just tight into the corners. A bulging joint or pucker along the Gasket
indicates a Gasket section that is cut too long. Joints that pull apart indicate a Gasket section (or
sections) that is cut too short.
IMPORTANT: MAKE SURE THAT THE GASKET AND THE DOOR FRAME ARE
BOTH CLEAN AND COMPLETELY DRY BEFORE APPLYING ANY SEALANT!
G. Seal the corner joints after the entire Gasket is properly fitted. Pull the joints apart only enough
to put sealant on all the cut edges only. Allow the Gasket joint to come together. Smooth out
any excess sealant to form a smooth surface on the face of the Gasket. Add more sealant to
any spots as necessary and smooth them down.
H. A quality seala nt will be dry to the touch and tack-free in one to two hours after application.
However, it will not be completely cured until six to eight hours later. We recommend that you
wait until after your sealant is completely cured before using your Oven or Proofer.
WARNING: SOME SEALANTS GIVE OFF ACIDIC FUMES AS THEY CURE.
THESE FUMES MAY CAUSE IRRITATION TO THE EYES AND/OR NASAL
PASSAGES. USE CAUTION WHEN OPENING YOUR UNIT AFTER WAITING FOR
ANY FRESH SEALANT TO SET UP AND/OR CURE!

CASTER, How To Replace:

MAKE SURE ALL POWER TO THE UNIT IS OFF. FAILURE TO DO SO MAY CAUSE
SEVERE EQUIPMENT DAMAGE OR PERSONAL INJURY!
The Casters [77] on this unit are maintenance free. However, it is occasionally necessary to replace
one or more due to shipping damage or improper handling. This can be done either by raising the unit
off of the floor by one or two inches or laying the entire unit on its back.

To Raise Unit Off the Floor - -

A. Disconnect any service lines (electrical or water) to the unit. Move the unit to an area enabling
you to reach the Caster to be replaced.
B. Engage all Caster locks.
NU–VU® FOOD SERVICE SYSTEMS
(800) 338-9886
PO BOX 35
SALES FAX (906) 863-5889 • SERVICE FAX (906) 863-6322
SERVICE AND REPLACEMENT GUIDE
MENOMINEE, MICHIGAN 49858-0035
page 41