Western Digital My Cloud EX2 User Manual page 15

Label
Replacement
drive
Green board
facing in
Note: You'll need a phillips-head screwdriver for this procedure.
Note: The power and network cables are not connected when you do this.
1. Press the indented button on the door (top) of the device and open the top.
2. Remove the bracket that will hold the drives in place.
3. Using a screw from the bag, attach a plastic tab to the top hole in the drive's side (on the
right if the green board is facing you).
4. Insert a screw in the corresponding hole on the other side of the drive.
5. Attach labels 1 or 2 to the top of the drive. Label 1 is on the left and label 2 is on the
right, when looking down on the top of the unit. There are corresponding numbers on
the cross brace label.
6. When looking down on the top of the unit with the front panel towards you, and with the
connectors at the bottom of the drive facing in, gently slip the drive into a slot.
7. Make sure the tab is sticking up at the back of the unit.
WD MY CLOUD EX2 PERSONAL CLOUD STORAGE
USER MANUAL
Bracket
Screw
Tab
GETTING STARTED
10