Network Interface Card - Kyocera FS-1020D Operation Manual

A.4

Network Interface Card

If the serial interface board kit is installed, remove it to use the network
interface card.
ote
Insert the option network interface card into the option interface slot at the
rear of the printer. The network interface card enables the printer to be
used in a network.
1
Turn off the printer and disconnect the power cord and printer cable.
2
Remove the two screws from the option interface slot cover and
remove the slot cover.
Screws
Figure A-15
3
Insert the network interface card and secure it with the screws
removed in step 2.
Figure A-16
Option Interface Slot Cover
Network Interface Card
Screws
A-10
Network Interface Card