7
7.3
IPP Printing (Windows 2000)
This section explains how to use the Windows 2000 standard IPP printing
function.
Before You Begin
Check the following points.
l The TCP/IP settings should be specified from the control panel of the
Digital Copier. (Refer to "6 Digital Copier Settings for Use on a
Network" on page 6-1.)
l The IPP settings should be specified using the enclosed PageScope
Light. For details, refer to the PageScope Light for Pi1802e User
Manual.
l Check that the "TCP/IP protocol" has been installed on Windows
2000.
l Turn on the Digital Copier.
Installing the Printer Driver
When the printer driver is installed, set up IPP printing.
1
Click the [Start] button, point to [Settings], and then click [Printers].
2
Double-click the "Add Printer" icon to start the Add Printer Wizard.
3
Click the [Next] button.
4
On the "Local or Network Printer" page, select the "Network printer"
option, and then click the [Next] button.
5
On the "Locate Your Printer" page, select the "Connect to a printer on
the Internet or your intranet" option.
6
Type the IPP printer's URL into the "URL" box as shown below, and
then click the [Next] button.
http://<IP address of the Network Interface Card>/ipp.cgi
(Example) When the IP address of the Network Interface Card is
192.168.0.10:
http://192.168.0.10/ipp.cgi
If the network you are on uses DNS (Domain Name Services), enter
the DNS name instead of the IP address.
7
Click the [OK] button on the confirmation dialog box that appears.
7-8
Network Printing in a Windows Environment
Pi1802e