Table of Contents
Advertisement
Network Printing in a Windows Environment
7
Network Printing in a Windows
Environment
NOTE
è
If the Digital Copier is to be used as a printer on a network, the
optional network interface card NC-3 must be installed. In addition,
connect the printer to the network according to the procedure
described in "2.2 Connecting to the Ethernet 10/100Base-T Port
(Network Connection)" on page 2-3.
The network interface card NC-3 supports TCP/IP and IPX/SPX protocol.
7.1
Peer-to-Peer Printing (Windows 95/98/Me)
Peer-to-peer printing can be performed using TCP/IP.
Before You Begin
Check the following points.
l Specify the TCP/IP settings from the control panel of the Digital
Copier. At that time, specify a fixed IP address, not DHCP (automatic
setting). (Refer to "6 Digital Copier Settings for Use on a Network" on
page 6-1.)
l Check that the "TCP/IP" protocol has been installed on Windows.
l Turn on the Digital Copier.
Settings for Windows 95/98/Me
1
Install the printer driver for Windows 95/98/Me. For details on the
installation procedure, refer to "3.1 Windows 95/98/Me" on page 3-2.
During installation, set up the printer as a local printer.
2
Right-click the new printer icon and select "Properties" from the
menu.
3
Display the [Details] tab on the Properties dialog box.
Pi1802e
7
7-1
Advertisement
Table of Contents
