Hitachi VT-FX616A Owner's Manual page 34

5. Turn on your cable box and tune it to channel 02.
6. Enter the output channel of your cable box by pressing a number on the remote. For example,
press 0 3 for channel 3.
7. Press MENU to enter the output channel of your cable box. You will then see this screen.
8. Press MENU to display the CABLE BOX TYPE message on the TV screen.
9. Enter your cable box type from the chart below by pressing two numbers.
10. Press MENU to enter your cable box type. The VCR will change the cable box from channel
02 to channel 09 when you enter the correct code for your cable box.
11. Cable box tuned to channel 9: Press number 2 on the remote. Your cable box and VCR are
now set for VCR Plus+ program recording. In most cases, you can use the number buttons on the
remote to change the channels on your cable box. (The VCR channel will not change, but the
cable box will change channels.)
Cable box did not tune to channel 9: Press number 1 on the remote and enter a different code
from the chart.
If these codes do not work:
• Try repositioning the cable box on top of the VCR and reentering the codes.
34