Applications; Installation; Preparation Before Operation - Hitachi C 10FCE User Manual

English

APPLICATIONS

Wood and aluminum sash.

PREPARATION BEFORE OPERATION

Make the following preparations before operating the power tool:

1. Installation

11/32" (9mm)
4 Holes
16-11/16" (424mm)
Attach the power tool to a level, horizontal work bench in accordance with Fig. 4.
Select 5/16" (8mm) diameter bolts suitable in length for the thickness of the work bench.
Bolt length should be at least 1-3/8" (35mm) plus the thickness of the work bench.
For example, use 2-11/32" (60mm) or larger bolts for a 1" (25mm) thick work bench.
The holder attached to the rear of the base helps stabilize the power tool.
6mm Bolt
Holder (B)
Adjust the holder
Move
until its bottom
surface contacts the
work bench surface.
Fig. 5
10
5/16" (8mm) Bolt
Work Bench
Fig. 4
Holder (B) adjustment:
Loosen the 6mm bolt with the supplied 10mm box wrench.
Adjust the holder (B) until its bottom surface contacts the work
bench surface.
After adjustment, firmly tighten the 6mm bolt.
CAUTION:
Attach the power tool to a work bench with bolts
(6mm), and if the turntable has been swiveled 45°
degrees or more, be careful not to let the hand
that is holding the side handle get caught between
the side handle and heads of bolts (6mm). Injuries
could result.
Base
5/16" (8mm) Nut