Sony RM-VL700T Operating Instructions Manual page 9

3
Press the Component Select
button for the desired
component.
The selected Component
button lights up, and all other
buttons turn off.
4
Press the Number buttons
to enter the three-digit
component code number.
5
Press ENT.
The Component Select button
turns off.
If the Component Select button
flashes five times before
turning off, it means that the
setup is incomplete. Start over
from Step 2.
Notes
• If you press a component code
number that is not on the table in the
supplied "Component Code
Numbers", or if you press a button in
the wrong order, the Component
button flashes five times, and then
turns off. Check the component code
number, and try setting it again.
• If you don't input anything into the
Commander within 20 seconds
between each step, the setup
procedure will be cancelled. To set the
code, start over from Step 2.
• If you press SET while setting the
component code, all code numbers
will be lost, and the setup procedure
will be cancelled. Start over from Step
2.
To cancel setup, press SET.
Continued
GB
9