Static Route Edit; Figure 128 Static Route; Table 75 Static Route - ZyXEL Communications P-660HW-Tx v3 User Manual

Chapter 14 Static Route

Figure 128 Static Route

The following table describes the labels in this screen.

Table 75 Static Route

LABEL
#
Active
Name
Destination
Gateway
Subnet Mask
Modify

14.2.1 Static Route Edit

Select a static route index number and click Edit. The screen shown next appears. Use this
screen to configure the required information for a static route.
202
DESCRIPTION
This is the number of an individual static route.
Select the check box to activate this static route. Otherwise, clear the check box.
This is the name that describes or identifies this route.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward
packets to their destinations.
This is the IP subnet mask.
Click the Edit icon to go to the screen where you can set up a static route on the
ZyXEL Device.
Click the Delete icon to remove a static route from the ZyXEL Device. A window
displays asking you to confirm that you want to delete the route.
P-660HW-Tx v3 User's Guide