Set Up Instructions - Stamina InMotion E3000 Owner's Manual

SET UP INSTRUCTIONS

Place the InMotion® E3000 in the area where it will be used. It is recommended that the InMotion®
E3000 be placed on an equipment mat. The maximum operation dimensions of the InMotion® E3000
are approximately 30.2 inches long x 18.5 inches wide x 48.8 inches tall. (These dimensions may vary up
to one inch.) Make sure that adequate space is available for access to, passage around and emergency
dismount from the InMotion® E3000. A minimum of 20 inches on at least one side and 20 inches either
behind or in front of the InMotion® E3000 is required for safe operation.
LEVELING: Adjust the location of InMotion® E3000 to ensure InMotion® E3000 sits on the floor
without rocking.
MOVING: Grasp the REAR STABILIZER(2) and HANDLEBAR(72) to move the InMotion® E3000.
Do not use the PEDAL ARMS(3,4) to move the InMotion® E3000. The PEDAL ARMS(3,4)
will move and may pinch your hand or fingers.
FUNCTION INSPECTION:
Visually inspect the InMotion® E3000 to verify that assembly is as shown in the above illustration. Check
the function of the InMotion® E3000. Stand on the foot pedals. Slowly move your highest foot forward
and follow the natural path of the machine. Turn the crank slowly through one complete revolution to verify
that the drive train functions properly. Adjust the TENSION KNOB(21) and verify that it functions properly.
CAUTION: Locate and read the WARNING LABEL(55) on the InMotion® E3000. Make sure that all
users read the WARNING LABEL(55).
Equipment Mat
9