Set Up Instructions - Stamina Total Body Pro Elliptical 55-1702 Owner's Manual

SET UP INSTRUCTIONS

Place the STAMINA® Total Body Pro Elliptical in the area where it will be used. It is recommended that the
STAMINA® Total Body Pro Elliptical be placed on an equipment mat. The maximum operation dimensions
of the STAMINA® Total Body Pro Elliptical are approximately 40.8 inches long x 24.8 inches wide x 60.4
inches tall. (These dimensions may vary up to one inch.) Make sure that adequate space is available for
access to passage around and emergency dismount from the STAMINA® Total Body Pro Elliptical. A
minimum of 20 inches on at least one side and 20 inches either behind or in front of the STAMINA® Total
Body Pro Elliptical is required for safe operation.
LEVELING: Adjust the LEVELING CAPS(57) on the REAR STABILIZER(3) so that the STAMINA® Total
Body Pro Elliptical sits on the floor without rocking. Remove and reposition the LEVELING
CAPS(57) on the REAR STABILIZER(3) to level the STAMINA® Total Body Pro Elliptical.
MOVING: Grasp the pivot tubes on the PIVOTING ARMS(9, 10) and REAR STABILIZER(3) to move
the STAMINA® Total Body Pro Elliptical, two people are required for moving. Do not use
the PEDAL ARMS(4, 5) to move the STAMINA® Total Body Pro Elliptical. Be sure to use
caution as the PEDAL ARMS(4, 5) will move and may pinch your hand or fingers.
FUNCTION INSPECTION:
Visually inspect the STAMINA® Total Body Pro Elliptical to verify that assembly is as shown in the
above illustration. Check the function of the STAMINA® Total Body Pro Elliptical by turning the crank
slowly through one complete revolution to verify that the drive train functions properly. Adjust the TENSION
KNOB(31) to verify that the adjustable tension is working properly.
CAUTION: Locate and read the WARNING LABEL(76) on the STAMINA® Total Body Pro Elliptical.
Make sure that all users read the WARNING LABEL(76).
Grasp here to move
Equipment Mat
13
Grasp here to move
(not included)