Set Up Instructions - Stamina 703 Owner's Manual

SET UP INSTRUCTIONS

Place the Stamina® Elliptical Trainer 703 in the area where it will be used. It is recommended that the
Stamina® Elliptical Trainer 703 be placed on an equipment mat. The maximum operation dimensions of
the Stamina® Elliptical Trainer 703 are approximately 46.3 inches long x 25.7 inches wide x 63 inches
tall. (These dimensions may vary up to one inch.) Make sure that adequate space is available for access
to move around and emergency dismount from the Stamina® Elliptical Trainer 703. A minimum of 20
inches on at least one side and 20 inches either behind or in front of the Stamina® Elliptical Trainer 703
is required for safe operation.
LEVELING: Adjust the LEVELING CAPS(39) on the REAR STABILIZER(6) so the Stamina® Elliptical
Trainer 703 sits on the floor without rocking. Remove and reposition the LEVELING
CAPS(39) on the REAR STABILIZER(6) to level the Stamina® Elliptical Trainer 703.
MOVING: The Stamina® Elliptical Trainer 703 has a pair of Wheels in the WHEEL CAPS(38) on
the FRONT STABILIZER(3). Grasp on the STATIONARY HANDLEBAR(26) and tip the
Stamina® Elliptical Trainer 703 forward to move.
FUNCTION INSPECTION:
Visually inspect the Stamina® Elliptical Trainer 703 to verify that assembly is as shown in the above
illustration. Check the function of the Stamina® Elliptical Trainer 703, stand on the PEDAL CAPS(33, 34)
and place your hands at a comfortable position on the HANDLEBARS(4, 5). Slowly move the crank through
one complete revolution to verify that the drive train functions properly. Adjust the TENSION KNOB(29) and
verify that it functions properly and the resistance changes.
CAUTION: Locate and read the CAUTION LABEL(89) on the Stamina® Elliptical Trainer 703. Make
sure that all users read the CAUTION LABEL(89) before using the product.
Equipment Mat
13