Usb Wake-Up; Watch Dog Enable/Disable; Bmc Jumper - Supero H8DCL-i User Manual

H8DCL-i/6(F) Serverboard User's Manual

USB Wake-Up

JPUSB1 jumper allows you to "wake up"
the system by pressing a key on the USB
keyboard or by clicking the USB mouse of
your system. These jumpers are used in
conjunction with the USB Wake-Up function
in the BIOS. See the table on the right for
jumper settings and jumper connections. (the
default is Enabled)

Watch Dog Enable/Disable

JWD1 enables the Watch Dog function, a
system monitor that takes action when a
software application freezes the system.
Jumping pins 1-2 will have WD reboot the
system if a program freezes. Jumping pins
2-3 will generate a non-maskable interrupt for
the program that has frozen. See the table
on the right for jumper settings. Watch Dog
must also be enabled in BIOS.

BMC Jumper

JPB1 is used to enable or disable the BMC
(Baseboard Management Control) Chip and
the onboard IPMI connection.This jumper is
used together with the IPMI settings in the
BIOS. The default position is on pins 1 and
2 to Enable BMC. See the table on the right
for jumper settings.
Wake-Up Enable (JPUSB1)
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Jumper Settings (JWD1)
Jumper Setting
Pins 1-2
Pins 2-3
Open
Note: When Watch Dog is enabled,
the user must write their own
application software to disable the
Watch Dog Timer.
BMC Jumper Enable (JPB1)
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
2-18
Backpanel USB
Defi nition
Enabled (default)
Disabled
Watch Dog
Defi nition
Reset
NMI
Disabled
Defi nition
Enabled (default)
Disabled