Table of Contents
Advertisement
Power On LED
The Power On LED connector is located
on pins 15 and 16 of JF1. This connection
is used to provide LED indication of power
being supplied to the system. See the table
on the right for pin defi nitions.
NMI Button
The non-maskable interrupt button header is
located on pins 19 and 20 of JF1. Refer to the
table on the right for pin defi nitions.
Universal Serial Bus Ports
Two Universal Serial Bus ports (USB 2.0) are
located beside the Keyboard and Mouse PS2
ports (USB0/1). One additional Type A port
(USB6) is included on the motherboard. See
the table on the right for pin defi nitions.
USB Headers
Four USB 2.0 headers (USB2/3 and USB4/5)
are also included on the motherboard. These
may be connected to provide front side
access. A USB cable (not included) is needed
for the connection. See the table on the right
for pin defi nitions.
JIBTN1 Header
(optional for H8DCL-6(F))
A RAIDKey header, located at JIBTN1,
provides RAID function support in order to
use RAID 5 SAS2 support.
Pin# Defi nition
15
16
Pin# Defi nition
19
20
Universal Serial Bus Ports
Pin Defi nitions (USB 0/1,
USB0
Pin # Defi nition
1
+5V
2
PO-
3
PO+
4
Ground
Universal Serial Bus Headers
Pin Defi nitions (USB2/3,
USB2
Pin # Defi nition
1
+5V
2
PO-
3
PO+
4
Ground
5
Key
Note: NC indicates no connection.
2-11
Chapter 2: Installation
Power LED
Pin Defi nitions
(JF1)
5V Stby
Control
NMI Button
Pin Defi nitions
(JF1)
Control
Ground
USB6)
USB1
Pin # Defi nition
1
+5V
2
PO-
3
PO+
4
Ground
USB4/5)
USB3
Pin # Defi nition
1
+5V
2
PO-
3
PO+
4
Ground
5
NC
Advertisement
Table of Contents
