H8DCL-i/6(F) Serverboard User's Manual
PW_ON Connector
The PW_ON connector is on pins 1 and 2 of
JF1. This header should be connected to the
chassis power button. See the table on the
right for pin defi nitions.
Reset Connector
The reset connector is located on pins 3 and
4 of JF1 and attaches to the reset switch on
the computer chassis. See the table on the
right for pin defi nitions.
Overheat/Fan Fail LED (OH)
Connect an LED to the OH connection on
pins 7 and 8 of JF1 to provide advanced
warning of chassis overheating or fan
failure. Refer to the table on the right for pin
defi nitions and status indicators.
NIC2 (LAN2) LED
The LED connections for LAN2 are on pins
9 and 10 of JF1. Attach LAN LED cables to
display network activity. See the table on the
right for pin defi nitions.
NIC1 (LAN1) LED
The LED connections for LAN1 are on pins
11 and 12 of JF1. Attach LAN LED cables to
display network activity. See the table on the
right for pin defi nitions.
HDD LED
The HDD LED connection is located on pins
13 and 14 of JF1. Attach the hard drive LED
cable here to display disk activity (for any
hard drives on the system, including SAS,
Serial ATA and IDE). See the table on the
right for pin defi nitions
Pin# Defi nition
1
2
Pin# Defi nition
3
4
OH/Fan Fail LED
Pin Defi nitions
(JF1)
Pin# Defi nition
7
Vcc
8
Control
Pin# Defi nition
9
10
Pin# Defi nition
11
12
Pin# Defi nition
13
14
2-10
Power Button
Pin Defi nitions
(JF1)
PW_ON
Ground
Reset Button
Pin Defi nitions
(JF1)
Reset
Ground
OH/Fan Fail
LED Status
State
Indication
Solid
Overheat
Blinking
Fan fail
NIC2 LED
Pin Defi nitions
(JF1)
Vcc
Ground
NIC1 LED
Pin Defi nitions
(JF1)
Vcc
Ground
HDD LED
Pin Defi nitions
(JF1)
Vcc
HD Active