Card Reader/Usb 3.0 Board - HP EliteBook 8770w Maintenance And Service Manual

Card reader/USB 3.0 board

Description
Card reader/USB 3.0 board
Before removing the card reader/USB 3.0 board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service access cover (see
6. Remove the optical drive (see
bay hard drive on page
7. Remove the keyboard (see
8. Remove the top cover (see
Remove the card reader/USB 3.0 board:
1. Position the computer right-side up with the front toward you.
2. Remove any plastic blanks in the card reader slots.
3. Remove the 3 Phillips M2.5x3.0 screws (1) that secure the card reader/USB 3.0 board to the
base enclosure.
4. Lift the left side (2) of the card reader/USB 3.0 board to disconnect it from the system board.
Reverse this procedure to install the card reader/USB 3.0 board.
102 Chapter 4 Removal and replacement procedures
Battery on page 51).
Service access cover on page
Optical drive on page
66).
Keyboard on page
Top cover on page
63) or upgrade bay hard drive (see
71).
83).
Spare part number
689283-001
52).
Upgrade