Automation; Touch Function; Undo (Static) - Tascam DM-24 Release Notes

DM-24 version 2.0—Release notes—Automation

Automation

Touch function

The touch function is used to overwrite and erase
POD, rotary encoder or switch moves. Since these
controls are not touch-sensitive, this is a useful way
to erase previous mix moves on these controls.
1 sec
+12
+6
+3
0
-3
-6
-12
1 sec
+12
+6
+3
0
-3
-6
-9
-12
Press/Hold
TOUCH
&
Move control
To operate the touch function:
Enable Global Write mode.
1
Press and hold the
2
TOUCH
holding it, operate the non touch-sensitive
control (PODs, rotary encoders or switches)
to begin writing or overwriting at the con-
trol's current value. While moving the con-

UNDO (static)

The key now can be used to undo adjustments
UNDO
made to a static control during a mix pass, as well as
its previous "undo all mix moves" function.
22
TASCAM DM-24 2.0 release notes
Existing Move
2 sec 3 sec 4 sec
Mix Move
2 sec 3 sec
4 sec
Control
Writing
New Move
key and while
The relationship between the previous mix moves
and moves made using the touch function is shown
below
7 sec
5 sec 6 sec
5 sec 6 sec 7 sec
Revert
Time
Auto or Manual
Revert
trol, you can release the
mode is still enabled for this control.
Make a new mix move or end writing manu-
3
ally by pressing the
If a new move is written, the revert action
follows the settings made on the
screen.
8 sec
8 sec
key. Write
TOUCH
key.
REVERT
AUTO MAIN