Digital Outputs And Aux Sends - Tascam DM-24 Release Notes

DM-24 version 2.0—Release notes—I/O setup changes
If an optional IF-AN/DM analog card is fitted, (see
"New output assignment options" on page 7), busses
1 through 8 can be used like post-fader analog effect
sends, with the analog returns fed through the mic/
line inputs and routed through aux 1 and 2 to the ste-
reo buss.
The assignment of a mic/line channel to the aux 1
and 2 busses is made on the
well as the screens:
AUX SOURCE
On the screen, the
MODULE SETUP
(additional source) parameter for modules 1 through
16 can be set to or
RETURN
vidually for each channel.
On the screens (aux 1 and 2 are linked
AUX SOURCE
on the screen here), the source for channels 1 through
16 can be selected either from
/ / , depending on the
PRE POST M/L
for the channel:

Digital outputs and Aux sends

Previously, Aux sends had to be paired (1-2, etc.,) in
order to output them from the digital outputs.
12
TASCAM DM-24 2.0 release notes
screen as
MODULE SETUP
ADD. SOURCE
. This can be set indi-
M/L
/ / or
PRE POST RETURN
setting
ADD. SOURCE
At the bottom of this screen is a
allows you to make a "master" assignment setting.
Use POD 1 to set the parameter to
set the scope of the assignment to
highlight the button and press
SET
1 through 16 will be set to
unchanged).
Use the screen to highlight the AUX 1-
ASSIGN BUSS
2 to stereo assignment section, and press the
( section).
CH ASSIGN
Link aux 1 and 2 using the
the screen, move the cursor to aux 1, and
ST LINK
press .
ENTER
You can use the
AUX 1-2 LEVEL
screens to set the level and pan values for these M/L
inputs, just as for any other channel. These level and
pan settings affect the signals sent to the stereo mas-
ter buss.
Remember that the input level of these signals is
determined by the analog
section which
SETUP
and POD 2 to
M/L
. When you
ALL
, channels
ENTER
(17 through 32 remain
M/L
key
ST
key to get to
LINK/GRP
and
AUX 1-2 PAN/BAL
controls.
TRIM