Snapshot Recall; External Machine Control; Play (Mmc); Track Arming - Tascam DM-24 Release Notes

DM-24 version 2.0—Release notes—External machine control

Snapshot recall

When a snapshot is recalled, MIDI Control Change
messages are output, which correspond to the new
settings of the following:
• Faders
• Mute status
• Pan controls

External machine control

When operating an external device

Play (MMC)

controlled by an open MMC loop, the command sent
when the key is pressed may now be selected
PLAY
between Deferred Play and True Play.
As a result, it is now possible to use the
control a number of DAW applications and HDR
machines using an open MMC connection.
On the

Track arming

MIDI/MC SETUP
a new parameter at the top right of the
section ( ).
CONTROL RecFn
Set this to either
TRUE(40h)
ously, only the
TRUE(40h)
units such as the Mackie HDR-24/96 and MDR-24/
96 require the
MASKED(41h)
now fully compatible with the Mackie recorder
family.
16
TASCAM DM-24 2.0 release notes
key to
PLAY
page, there is
MACHINE
or . Previ-
MASKED(41h)
command was used, but
setting. The DM-24 is
Additionally, when a snapshot is recalled using
MIDI, that snapshot is now shown as the current
snapshot in all screens.
Pressing the

Transport Lock

keys together locks the transport keys. This is useful
to stop accidental playback or recording when you
are leaning over the DM-24 adjusting parameters.
Press this key combination again to unlock the trans-
port keys. The popup changes

Internal MIDI Time Code generator

DM-24 now has its own generator, which can be used
with DAWs, etc. which do not respond to MMC
commands. By slaving them to MTC from the DM-
24, you can use the transport keys of the DM-24 to
control these DAWs.
and
2ND F. STOP
The