Intermec CK3 User Manual page 58

Chapter 2 — Connecting and Configuring the CK3
46
Configuring LEAP Security on Your CK3
1 Make sure the communications and radio parameters on your
CK3 are configured.
2 Make sure Funk is selected as your security choice.
3 Start Intermec Settings.
4 Choose Communications > 802.11 Radio > Funk Security.
5 Select the profile you want to configure.
6 For 8021x, choose LEAP and press Enter.
7 For Association, choose Open, WPA, WPA2, or Network EAP
and press Enter. Encryption automatically defaults to TKIP if you
choose WPA, AES if you choose WPA2, and WEP if you choose
Open or Network EAP.
8 For Prompt for Credentials, choose Enter credentials now.
9 Tap User Name, enter your user name, and press Enter.
10 Tap User Password, enter your password, and press Enter.
11 Save your settings and exit Intermec Settings.
Configuring Static WEP Security With Funk Security
1 Make sure the communications and radio parameters on your
CK3 are configured.
2 Make sure Funk is selected as your security choice.
3 Start Intermec Settings.
4 Choose Communications > 802.11 Radio > Funk Security.
5 Select the profile you want to configure.
6 For Association, choose Open and press Enter.
7 For Encryption, choose WEP and press Enter.
8 For 8021x, choose None.
9 Define a value for the keys you want to use. You can define up to
four keys (Key 1 through Key 4).
Enter an ASCII key or a hex key that is either 5 bytes or 13 bytes
long depending on the capability of the radio. Set a 5- byte value
CK3 Mobile Computer User's Manual