Fujitsu MAW3073 SERIES Specifications page 149

Note:
These requirements shall be satisfied if any device supplies the TERMPWR.
b. Single-ended output signal characteristics
An active negate driver shall be used for single-ended line signals. This driver can be in the Assert,
Negate, or High-Impedance state. Each signal supplied by the SCSI device shall have the following
output characteristics when measured at the connector position of SCSI device:
1) V (Low-level output voltage) = 0.0 to 0.5 VDC if I
OL
2) V (High-level output voltage) = 2.5 to 3.7 VDC (Signal negate state)
OH
3) The output characteristics (in signal negate state) shall be limited to allow operations in
the non-shaded areas only of Figure 1.53.
C141-C011
=48 mA (Signal assert state)
OL
1-131