i.
System board (see
j.
Pen holder (see
Remove the audio/infrared board:
1.
Remove the two Phillips PM2.0×3.0 screws (1) that secure the audio/infrared board to the
system board.
2.
Release the audio/infrared board (2) by sliding it away from you until the connectors on the front
of the board disengage from the openings in the base enclosure.
3.
Remove the audio/infrared board (3).
Reverse this procedure to install the audio/infrared board.
66
Chapter 4 Removal and replacement procedures
System board on page
Pen holder and pen eject assembly on page
61)
64)