Top Cover - HP TouchSmart tx2 Maintenance And Service Manual

Top cover

Description
Top cover (includes TouchPad and TouchPad cable, caps lock light board and cable, and top
cover bumper pads)
Before removing the top cover, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power cord.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Optical drive (see
c. Keyboard (see
d. Switch cover (see
e. Display assembly (see
Remove the top cover:
1. Turn the computer upside down, with the front toward you.
2. Remove the five Phillips PM2.0×7.0 screws (1) and the three Phillips PM2.0×4.0 screws (2) that
secure the top cover to the computer.
3. Turn the computer right-side up, with the front toward you.
4. Disconnect the display lid switch board cable (1) from the system board.
56 Chapter 4 Removal and replacement procedures
Battery on page 38).
Hard drive on page 40)
Optical drive on page
Keyboard on page 49)
Switch cover on page
Display assembly on page
43)
51)
53)
Spare part number
506824-001