Memory Module - HP TouchSmart tx2 Maintenance And Service Manual

Memory module

Description
4096-MB (DDR2, PC2-6400, 800-MHz)
2048-MB (DDR2, PC2-6400, 800-MHz)
1024-MB (DDR2, PC2-6400, 800-MHz)
Before removing the memory module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power cord.
4. Remove the battery (see
Remove the memory module:
1. Position the computer with the front toward you.
2. Loosen the two Phillips PM2.0×5.0 captive screws (1) that secure the memory module
compartment cover to the computer.
3. Lift the left side of the cover (2) and swing it to the right.
4. Remove the memory module compartment cover.
NOTE:
number 487926-001.
5. Spread the retaining tabs (1) on each side of the memory module slot to release the memory
module. (The edge of the module opposite the slot rises away from the computer.)
44 Chapter 4 Removal and replacement procedures
Battery on page
The memory module compartment cover is included in the Plastics Kit, spare part
38).
Spare part number
598855-001
598858-001
598861-001