Upa-700 Rear Panel - Emotiva UPA-700 User Manual

UPA-700 Rear Panel

1 2
FR
CH 7
STATUS LEDS
OFF ON
INPUT OUTPUT
1. Trigger Input and Trigger Output
The UPA-700 is switched On (from Standby) when a trigger signal is presented at the
Trigger Input; the UPA-700 returns to Standby when the trigger signal is removed. When the
UPA-700 is on, a 12 VDC signal is sent from the Trigger Output to control other devices.
2. Status LED Switch
Enables and disables the front panel Channel Status LEDs.
3. Speaker Outputs (7 sets)
Full-sized, five-way binding posts; accept 4 Ohm or 8 Ohm speakers (+ red; - black).
4. RCA (unbalanced) Inputs (7)
Unbalanced audio input (gold plated RCA jack).
5. Line Voltage Indicator
The UPA-700 automatically detects 115 VAC or 230 VAC line voltage. These indicators
show which line voltage is in use.
6. AC Power Switch
Switches the mains AC power to the UPA-700 On and Off. When this switch is off, no
controls operate (the UPA-700 cannot be turned On by the front panel or a trigger signal).
7. IEC Power Cord Receptacle
Accepts a standard removable IEC AC power cable. If you replace this, only use power
cables of sufficient current capacity.
UPA-700
3 4
RS RBS Center
CH 6 CH 5 CH4
LBS LS FL
CH 3 CH 2 CH 1
Page 8
5 6 7
115V
1
|
0
POWER
|
230V