Xpa Hc-1 Rear Panel - Emotiva XPA HC-1 User Manual

XPA HC-1 Rear Panel

1. Status LEDs Switch
Disables the front panel status LED when set to Off.
2. Trigger Input and Trigger Output
The XPA HC-1is switched On (from Standby) when a trigger signal is presented at the Trigger
Input; the XPA HC-1 returns to Standby when the trigger signal is removed. When the XPA HC-1 is
on, a 12 VDC signal is sent from the Trigger Output to control other devices.
3. Un-Balanced / Balanced Input Select Switch
A high-quality metal toggle switch selects between the Unbalanced (RCA) and Balanced (XLR)
input. Up selects the Unbalanced input and Down selects the Balanced input. Only one input can
be used at once. (Both a balanced and an unbalanced source may be connected at the same time,
and the switch used to select between them, but only one will be active at any given time.)
XPA HC-1
1 2
IN
TRIGGER
OUT
ON OFF
STATUS LEDS
CIRCUIT BREAKER
15A 125/250V~
POWER
7 8
6
3 4 5
INPUT SELECT
+
_
9
Page 9