Removing A Memory Module; Adding A Memory Module - Dell OptiPlex GX260 Series System User's Manual

Back to Contents Page
Memory
Dell™ OptiPlex™ GX260 Systems User's Guide
CAUTION: Before you begin any of the procedures in this section, follow the steps in
Instructions."
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before
opening the cover.
You can increase your computer memory by installing memory modules on the system board. For information on the type of
memory supported by your computer, see the "Memory" section in
1. Perform an orderly computer shutdown using the operating system menu.
NOTICE: To disconnect a network cable, first unplug the cable from your computer, and then unplug it from the
network wall jack.
2. Turn off any attached devices and disconnect them from their electrical outlets.
3. Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system
board.
4. If your computer has a stand and it is attached, remove the stand.
5. Open the computer cover.

Removing a Memory Module

1. Press out the securing clip at each end of the memory module connector.
2. Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.

Adding a Memory Module

1. Press out the securing clip at each end of the memory module connector.
Installing a Memory Module
"Technical Specifications."
"CAUTION: Safety