Dell OptiPlex GX260 Series System User's Manual page 87

Back to Contents Page
AGP and DVI Adapter Cards
Dell™ OptiPlex™ GX260 Systems User's Guide
CAUTION: Before you begin any of the procedures in this section, follow the steps in
Instructions."
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before
opening the cover.
Your Dell™ computer provides a connector for an AGP or DVI adapter card.
NOTE: The DVI adapter card works through your computer's integrated graphics. To control the adapter through your
operating system, click the Start menu, click Control Panel, and then click the integrated graphics driver's user-
interface icon.
1. Perform an orderly computer shutdown using the operating system menu.
2. Turn off any attached devices and disconnect them from their electrical outlets.
NOTICE:
To disconnect a network cable, first unplug the cable from your computer, and then unplug it from the
network wall jack.
3. Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system
board.
4. Remove the computer stand, if it is attached.
5. Open the computer cover.
Removing an AGP/DVI Adapter Card
1. Remove the filler bracket by raising the hinged lever and sliding the bracket up.
Press the intended tab on the hinged lever with your thumb until you release the tab. Continue holding the lever and
pull the lever up.
Filler Bracket Removal
"CAUTION: Safety