Closing The Computer Cover - Dell OptiPlex GX260 Series System User's Manual

Back to Contents Page

Closing the Computer Cover

Dell™ OptiPlex™ GX260 Systems User's Guide
1. Ensure that all cables are connected, and fold cables out of the way.
Gently pull the power cables toward you so that they do not get caught underneath the drives.
2. Ensure that no tools or extra parts are left inside the computer.
3. Close the cover:
a. Pivot the cover down.
b. Press down on the right side of the cover until it closes.
c. Press down on the left side of the cover until it closes.
d. Ensure that both sides of the cover are locked. If not, repeat this step.
NOTICE: To connect a network cable, first plug the cable into the network wall jack, and then plug it into the
computer.
4. Connect your computer and devices to electrical outlets, and turn them on.
After you open and close the cover, the chassis intrusion detector, if enabled, causes the following message to appear
on the screen at the next computer start-up:
ALERT! Cover was previously removed.
5. Reset the chassis intrusion detector
NOTE: If a setup password has been assigned by someone else, contact your network administrator for
information on resetting the chassis intrusion detector.
Back to Contents Page
by changing Chassis Intrusion to Enabled or Enabled-Silent.