Char-Broil 463232012 Product Manual page 21

14
Release the cap and nut from electronic ignition module. Attach electronic ignition module to the cart right side panel with
the nut and cap, shown A.
Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the Electronic Ignition
Module. otal (4) connections.
T
Connect the two wires(A and B) from the switch wiring harness into the back of the Electronic Ignition Module.
Total (2) connections.
NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown as A,B.
Electronic
ignition module
15
Insert hinge pin on bottom of doors into hole in bottom shelf. Press upper hinge pin in front brace, align hinge hole on top of
door, and release hinge pin into door.
A
Right side panel
Nut
Cap
Left door
1
2
A
3
4
B
Wire
PRESS
Right door
Top of
door
Hinge pin
on bottom
of door
21