Weider PLATINUM 831.153970 User Manual page 7

5. Insert the four connectors of the Lower Wire
Harness (72) into the sockets of the Upper Wire
Harness (71). The connectors should slide easi-
ly into the sockets and snap into place. If a con-
nector does not slide easily and snap into place,
turn the connector over and then insert it.
Make sure that the connectors and wires appear
as shown in the inset drawing. IF THE CONNEC-
TORS ARE NOT INSERTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Push the excess wire into the Upright (2).
Insert the Mech Frame (6) into the Base Plate (1).
Attach the Mech Frame (6) to the Upright (2) with
a 1/2" x 25mm Screw (133) and a 1/2" Lock
Washer (12). Do not tighten the Screw yet.
Attach the Mech Frame (6) to the Base Plate (1)
with four M10 Nylon Locknuts (103).
Tighten the 1/2" x 25mm Screw (133).
6. Press two Leg Outer Caps (62) onto the Leg (5).
Press an Oval Inner Cap (58) into the Leg.
Attach the Leg Lever Bumper (55) to the Leg (5)
with two M5 x 56mm Screws (119).
7. Remove the Seat Carriage (44) from the Rail (not
shown).
Attach the Seat (45) to the Seat Carriage (44)
with four M6 x 16mm Screws (118).
5
71
103
2
6
55
62
7
7
6
12
133
72
Tag
1
103
58
119
5
62
45
44
118
118
Tag