Weider PLATINUM 831.153970 User Manual page 11

19. Insert the Resistance Bow (9) between the
Crossbar Guides (15), and center it on the
Crossbar Block (not shown).
Press a Bracket Plate (11) and a Pulley Bracket
(10) onto the Resistance Bow (9). Screw a 3/8" x
38mm Tension Screw (13) into the Pulley Bracket
a couple of turns. Repeat on the other side of
the Resistance Bow.
20. Wrap the Crossbar Cable (99) around a "V"-pulley
(14). Attach the "V"-pulley to a Pulley Bracket (10)
with an M10 x 69mm Button Bolt (113) and an
M10 Nylon Locknut (103). Make sure that the
Cable is routed as shown in the CABLE DIA-
GRAM on page 20.
21. Wrap the Crossbar Cable (99) around a "V"-pulley
(14). Attach the "V"-pulley to the other Pulley
Bracket (10) with an M10 x 69mm Button Bolt
(113) and an M10 Nylon Locknut (103). Make
sure that the Cable is routed as shown in the
CABLE DIAGRAM on page 20.
Tighten the two 3/8" x 38mm Tension Screws
(13) an equal number of turns until the
Crossbar Cable (99) is tight.
22. Press two 25mm Square Inner Caps (34) into the
Backrest Frame (32). Attach the Backrest Cap
(33) to the Backrest Frame with two M4 x 16mm
Screws (111).
Attach a Plastic Foot (36) to the Backrest Frame
(32) with an M4 x 16mm Screw (111).
19
20
10
113
14
99
21
22
32
34
11
15
9
11
103
103
13
10
99
14
113
111
36
111
10
13
33