Hitachi KP-F140F Operation Manual page 19

-OFF-
Setting value 80000000 h
-ON-
Setting value 8xy0000z h
Readout signal polarity is switched at value of x. Readout signal source is switched at value of y. When set SourceID7,
if z is set to 1, a picture is outputted (and z becomes 0 automatically).
(3) TIME STAMP
The cycle timer value of 1394 buses can be added to image data as the time stamp.
-OFF-
Setting value 80000000 h
-ON-
Setting value 82000000 h
If TIME STAMP is ON, first 4 byte of image data is changed to time stamp information as follows.
｜ 0 h
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Second Count
(4) HD RESET
When using TRIGGER MODE, internal HD is reset and start exposure.
-OFF-
Setting value 80000000 h
-ON-
Setting value 82000000 h
(5) CYCLE TIMER SYNC
Camera is synchronized to cycle timer in same bus.
All camera set to normal mode and same frame rate.
-OFF-
Setting value 80000000 h
-ON-
Setting value 82000000 h
(6) PORT1 OUTPUT
PORT2 OUTPUT
Output strobe pulse / camera VD / other port input (switched PORT SETTING) from PORT1 / PORT2. These timing
can be signal timing of PORT1 and PORT2 for trigger operation.
-OFF-
Setting value 80000000h
Signal output absent.
-ON-
Setting value 8xyyyｚｚｚ h
When output signal is Strobe out/Camera VD, polarity is switched at value of x. When output signal is Other port input,
polarity is reversed or not reversed at value of x. When output signal is Strobe out/Other port input, adjust delay time
at value of yyy from 0.2 to 3931.4μs by 0.96μs step. When output signal is Strobe out, adjust output signal pulse
width at value of zzz from 0.96 to 3931.2μs by 0.96μs step. But, when zzz is set to 000h, Strobe out is stopped at
the time of end of exposure.
See "Trigger operation and timing chart" (page 13 to 16).
x: 2- LOW ACTIVE, 3- HIGH ACTIVE
y: 0- SourceID0(PORT1), 2- SourceID1(PORT2), E- SourceID7(Software)
z: 1- SET
| 1 h
Cycle Count
x: 2- LOW ACTIVE/THRUGH, 3- HIGH ACTIVE/REVERSE
yyy: 000h to FFFh
zzz: 000h to FFFh
(CSR: F200 000C h)
| 2 h
(CSR: F200 0010 h)
(CSR: F200 0010 h)
(CSR: F300 0200 h)
(CSR: F300 0204 h)
| 3h
Cycle Offset
|
9