Using your LinkStation
Sleep Timer
To save energy, you can specify times to put the LinkStation into sleep mode, where the hard disk
and LED lights are turned off. The sleep timer only works when the LinkStation's Power Mode Switch
is ON. This feature cannot be used when it is set to AUTO.
1
2
* You can set up to 3 timers.
* You can set ending time from 0:00 to 27:45.
You can set beginning time from 0:00 to 23:45.
(If the ending time is 24:00 or later, the beginning time can be set from 4:00 to 23:45.)
If 24:00 is equivalent to 0:00 of the next day, and 27:00 is equivalent to 3:00 of the next day.
* You can not set the ending time before or the same time as a beginning time.
•
During processing disk check, disk format, and backup jobs or when a backup job is
scheduled before and after 5 minutes of the current time, the LinkStation will not be
proceeded to Standby mode even though the end time has reached.
•
If time of the timers are duplicated, the longest interval time is used to operate.
LinkStation User Manual
1 In the Web Admin interface, navigate to [System]
- [Power Management] - [Sleep Timer]
2 Click [Modify Settings].
1 Specify a [Timer Interval],[Wake up at] and [Begin
Sleep at].
2 Click [Save] at the bottom of the screen.
88