Buffalo LinkStation User Manual page 165

Appendix
The Info/Error LED blinks red to indicate an error.
The error may be identified by the pattern of blinking.
Note: The error may also be viewed from NAS Navigator2.
Place
10s place
1s place
Error code Descriptions
E00 MPU is abnormal; no power. Contact Buffalo tech support for assistance.
E01 DRAM data line is abnormal. Contact Buffalo tech support for assistance.
E02 DRAM address line is abnormal. Contact Buffalo tech support for assistance.
E03 RTC chip is abnormal. Contact Buffalo tech support for assistance.
E04 Kernel extraction failed. Contact Buffalo tech support for assistance.
E14 The RAID array cannot be mounted. Turn off power, then turn power on again.
If the same error is displayed, re-configure RAID. And if the same error is displayed again, contact
Buffalo tech support for assistance.
E15 Hard drive I/O error. Contact Buffalo tech support for assistance.
E16 The hard drive is not connected, or data transfer has failed. Check your hard drive status. If the error
still remains, replace your hard drive.
E17 Controller error. Contact Buffalo tech support for assistance.
E21 Controller error. Contact Buffalo tech support for assistance.
E23 The hard drive has crashed. Replace your hard drive.
LinkStation User Manual
Status
The LED illuminates for 1 second every 0.3 seconds.
The number of flashes is the tens place of the error code.
The LED illuminates for 0.5 seconds every 0.3 seconds.
The number of flashes is the ones place of the error code.
164