Buffalo LinkStation User Manual page 164

Appendix
Info/Error LED
The Info/Error LED blinks orange when it has a message. The message is coded by the pattern of
blinking.
Note: The messages are also available (uncoded) in NAS Navigator2.
Place
10s place
1s place
Information code
I01
I11
I12
I13
I14
I15
I16
I17
I18
I19
I20
I21
I23
I25
I27
I28
LinkStation User Manual
Status
The LED illuminates for 1 second every 0.3 seconds.
The number of flashes is the tens place of the information code.
The LED illuminates for 0.5 seconds every 0.3 seconds.
The number of flashes is the ones place of the information code.
Descriptions
Checking the system area.
Many defective sectors have been found.
The RAID array is being degraded mode.
The RAID array is being formatted.
The RAID array is being checked.
The error status of the RAID array is being investigated.
Data transfers will be slower than usual until this is complete.
The RAID array is being created.
The RAID array is being resynchronized.
Data transfers will be slower than usual until this is complete.
The RAID array is being reconfigured.
Data transfers will be slower than usual until this is complete.
The RAID array is being erased.
Formatting the hard drive.
Checking the hard drive.
Initializing the system settings
Updating the firmware
Checking a USB drive
Formatting a USB hard drive
163