Buffalo LinkStation User Manual page 144

Chapter 4 Web Admin interface
Name
Maintenance
Notification
SMTP Server
Address
SMTP Port No.
Authentication Type Select [Authentication Type] from [POP before SMTP], [LOGIN(SMTP-
Email
Notification
POP3 Server
Click [Modify
Address
Settings]
POP3 Port No.
to change
SSL/TLS
settings.
Click [Send
Username
Test Message]
Password
to send a test
Subject
e-mail to the
e-mail address
Recipient(s)
which has
been set.
Report
Maintenance
Restart Restart the
LinkStation LinkStation
LinkStation User Manual
Descriptions
Select whether using E-mail notification feature or not. Following
message is sent by using E-mail Notification.
Note: Mail Server displays the list of [POP before SMTP] (the method to
give the permission to use SMTP server by authenticating at specified
POP server before sending e-mail). If this is set, this feature cannot be
used.
Enter [SMTP Server Address] (Mail Server Address).
Enter [SMTP Port No.].
AUTH)], and [CRAM-MD5(SMTP-AUTH/CRAM-MD5)].
Enter the [POP3 Server Address] (E-mail server address).
Enter [POP Port No.].
When [LOGIN(SMTP-AUTH)] and [CRAM-MD5(SMTP-AUTH/CRAM-
MD5)] are selected for [Authentication Type], specify either using [SSL]
or [TLS].
Enter a user name that will be used for authentication.
Enter the password used to access with above user name.
Specify the subject of the e-mail to be sent. Use only one-byte
characters, not two-byte characters.
Enter the e-mail address of the receiver, and click [Add]. You can
register up to 5 e-mail addresses as receivers.
Select the contents to send in the e-mail notification.
HDD Status Report]
• [
Send the status other hard drive of the LinkStation on the specified
time on [HDD Status Sending Time].
• [Fan Failure]
Sent if a problem on the fan of the LinkStation.
• [Disk Error]
Sent when an error occurs on the drive.
• [Backup Complete]
When the backup job is completed
Sent if the backup of the LinkStation is completed.
Click [Restart] to reboot the LinkStation.
143