Table of Contents
Advertisement
5.10 Rebooting the Hub
The Reboot operation reboots the ESP-2 serial hub. A reboot is usually required for
the following operations to take effect:
•
Changing network address values
•
Changing any configurable features
•
Updating FLASH
To reboot:
1.
From the Top Menu, enter
2.
From the Server Configuration menu, enter
You may also reboot the ESP-2 serial hub using the web interface (see Rebooting the
Hub on page 22) or the RESET button on the front panel (see Resetting on page 8).
5.11 Reinitializing the Hub
The Reinitialize command resets all configurable values to their factory defaults,
including the IP address and password.
To reinitialize:
1.
From the Top Menu, enter
2.
From the Server Configuration menu, enter
You may also reinitialize the ESP-2 serial hub using the web interface (see
Reinitializing the Hub on page 23) or the INIT button on the front panel (see
Reinitializing on page 8).
5.12 Displaying General Statistics
The General Statistics display includes the items described in Table 15 on page 20.
All values are cumulative since the ESP-2 serial hub was last reset.
To display general statistics:
1.
From the Top Menu, enter
2.
From the Status Menu, enter
5.13 Displaying Port Statistics
The Port Statistics display includes the information described in Table 16 on page 21
for each port.
All values are cumulative since the ESP-2 serial hub was last reset.
To display port statistics:
1.
From the Top Menu, enter
2.
From the Status Menu, enter
30
to select Server Configuration.
0
to select Server Configuration.
0
to select Re-Initialize (factory defaults).
7
to select Status.
3
to select General statistics.
1
to select Status.
3
to select Port statistics.
2
Equinox ESP-2 OPTO Serial Hub Installation and User Guide
to select Reboot.
5
Advertisement
Table of Contents
