Table of Contents
Advertisement
•
Frame/Parity/Overrrun - Number of framing errors, parity errors and overruns since the
unit was last rebooted.
This window refreshes every five seconds.
To display port statistics, select Port Statistics from the Main Menu.
Displaying Connected Servers Information
The Connected Servers window displays the following information about the servers that are
connected to the ESP-2 MI.
•
IP Address - Server's IP address
•
UDP State - Current UDP connection state
•
Initiating - Server is establishing a connection
•
Active - Server and ESP-2 MI are connected
•
Timeout - Connection is being dropped due to lost communication with the server
•
Terminated - Connection has been dropped
•
TCP State - Current TCP connection state
•
Initiating - Server is establishing a connection
•
Connected - Server and ESP-2 MI are connected
•
Terminated - Connection has been dropped
•
Connect Time - Number of days, hours, minutes and seconds server has been connected
•
Timeout Period - UDP time-out value; that is, amount of time before a connection is
dropped if no heartbeat messages are received
This window refreshes every five seconds.
To display connected server information, select Connected Servers from the Main Menu.
Rebooting the Unit
The Reboot window allows you to reboot the ESP-2 MI. A reboot is usually required after
changing any configuration values stored in EEPROM or after downloading new FLASH images.
To request a reboot:
1.
Select Reboot from the Main Menu.
2.
Click the Reboot button.
After the reboot, the web interface will try to reconnect to the unit. If this fails, or if the web
interface does not return within 30 seconds, direct your browser to the ESP-2 MI IP address.
You may also reboot the ESP-2 MI by pressing the RESET button on the front panel.
Reinitializing the Unit
The Initialize window allows you to reset all configurable values to their factory defaults,
including the IP address and password.
17
Equinox ESP-2 MI Serial Hub Installation Guide
Advertisement
Table of Contents
