Sharp R-8000E Service Manual page 57

FIXING PROCEDURE OF CORD ANCHORAGE
\
General :
Content:
As for the above subject, sometime it may cause to have wrong fixing about two pieces of cord anchorage
unit. But this cord anchorage is an important part for the safety, therefore it must be fixed correctly and
firmly.
1. The cord anchorage which is used to secure the mains supply cord can be futedin two different ways.
2. If you fuc them as shown in Figure 2, the mains supply cord will not be secured firmly.
3. Therefore, make sure to fuc them as shown in figure 1.
,3
mm
MAINS
SUPPLY
co?D
(UPPER) LSTPPOOO8YBFO
Figure 1. Correct Fixing
Figure 2. Wrong Fixing
56
:
s?C;h~=-~~ -.-.A _ -a. i