Turntable Motor Removal; Surge Limiting Relay Removal (Continental Europe Only) - Sharp R-8000E Service Manual

TURNTABLE MOTOR REMOVAL
1. Disconnect the oven power supply.
2. Remove the single (1) screw holding the turntable
motor cover to the bottom side of the chassis base.
3: Remove the turntable motor cover.
4. Remove the four (4) screws holding the turntable
motor mounting plate to the chassis base.
5. Take out the turntable motor with the wire leads and
mounting plate attached.
6. Disconned the wire leads from the motor. The motor
assembly is now free.
7. Remove the four (4) screws holding the turntable
motor to the mounting plate.
The motor is now free.
SURGE LIMITING RELAY REMOVAL
(Continental Europe only)
1. Disconned the oven power supply *and remove the
outer cace.
2. Discharge the high voltage capacitor.
3. Remove the power transformer, refer to "Power
Transformer Removal."
4. Disconnect the wire leads from the relay.
5. Remove the tow (2) screws holding the relay to the
main chassis.
Capaci tor mounting
?t
Main chassis Oven lamp access cover
,Surge limiting
. YAW resistor
Cord mounting bracket
Cord anchorage (lower)
-Turntable motor corer
Figure 12. Outer Case and Chassis Components
25