Table of Contents
Advertisement
Remote Control Codes for Components
Connected via RI
Components that are connected via
pointing the remote controller at the AV receiver, not the
component. This allows you to control components that are
out of view, in a rack, for example.
1
Make sure the component is connected with an
cable and an analog audio cable (RCA).
See "Connecting RI Components" for details
(➔ page 17).
2
Enter the appropriate remote control code for a
REMOTE MODE button, by referring to the
previous section.
42157:
Cassette tape deck with
81993:
Dock with
3
Press the REMOTE MODE button, point the
remote controller at the AV receiver, and operate
the component.
Resetting the REMOTE MODE Buttons
You can reset a REMOTE MODE button to its default
remote control code.
are controlled by
1
While holding down the REMOTE MODE button
that you want to reset, press and hold down HOME
until the remote indicator lights (about 3 seconds).
2
Within 30 seconds, press the REMOTE MODE
button again.
The remote indicator flashes twice, indicating that the
button has been reset.
Each REMOTE MODE button is preprogrammed
with a remote control code. When a button is reset, its
preprogrammed code is restored.
Resetting the Remote Controller
You can reset the remote controller to its default settings.
1
While holding down RECEIVER, press and hold
down HOME until the remote indicator lights
(about 3 seconds).
2
Within 30 seconds, press RECEIVER again.
The remote indicator flashes twice, indicating that the
remote controller has been reset.
En-76
Controlling Other Components
Controlling Other Components
By pressing the REMOTE MODE button that's been
programmed with the remote control code for your
component, you can control your component as described
below.
For details on entering a remote control code for other
components, see "Entering Remote Control Codes"
(➔ page 75).
Controlling a TV
TV is preprogrammed with the remote control code for
controlling a TV that supports the
some models). The TV must be able to receive remote
control commands via
and be connected to the
AV receiver via HDMI. If controlling your TV via
doesn't work very well, program your TV's
remote control code into TV and use the TV remote mode
to control your TV.
Use the following remote control codes:
11807/13100/13500:
TV with
Controlling Apple TV
By programming the supplied remote controller with the
appropriate remote control code, you can use it to operate
your Apple TV.
Use the following remote control codes:
02615:
Apple TV
*1
(limited to
- Quick Links:
- Connections
Hide quick links:
Advertisement
Table of Contents
