Setting The Zone 2/3 Out; Controlling Multi Zone Components - Tascam PA-R200 Instruction Manual

Setting the Zone 2/3 Out

See "Multi Zone" (➔ page 64).

Controlling Multi Zone Components

■
Operating on the AV receiver
Input selector buttons
ZONE 2 ZONE 3 MASTER VOLUME
STANDBY/ON
Tip
• The Whole House Mode function shares the input source of main
room with Multi Zone (➔ page 45).
1 To turn on Zone 2/3 and select an input source,
press ZONE 2 or ZONE 3 followed by an input
selector button within 8 seconds.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on the
AV receiver's display.
Tip
• The corresponding trigger output goes high (+12 V).
To select the same source as the main room's, press
ZONE 2 or ZONE 3 twice. "Z2 Sel: Source" or "Z3
Sel: Source" appears on the AV receiver's display.
2 To turn off Zone 2/3, press ZONE 2 or ZONE 3
followed by STANDBY/ON within 8 seconds.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
■
Operating on the remote controller
To control Zone 2/3, you must press ZONE2 or ZONE3
on the remote controller first.
RECEIVER
ZONE2
ZONE3
1 Press ZONE2 or ZONE3, then point the remote
controller at the AV receiver and press
RECEIVER.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on the
AV receiver's display.
Tip
• The corresponding trigger output goes high (+12 V).
2
To select an input source for Zone 2/3, press
ZONE2 or ZONE3, followed by an INPUT
SELECTOR button.
3
To turn off Zone 2/3, press ZONE2 or ZONE3,
followed by RECEIVER.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
En-69
Adjusting the Volume for Zone 2/3
■
Operating on the remote controller
1
Press ZONE2 or ZONE3.
INPUT
2
Use VOL / .
SELECTOR
MUTING
■
Operating on the AV receiver
VOL /
1
Press ZONE 2 or ZONE 3 (the Z2 or Z3 indicator
on the AV receiver's display flashes).
2 Use MASTER VOLUME control within 8 seconds.
If your Zone 2/3 speakers are connected to a receiver or
integrated amplifier in Zone 2/3, use its volume control to
adjust the volume.
Muting Zone 2/3
■
Operating on the remote controller
1 Press ZONE2 or ZONE3 followed by MUTING.
Tip
• To unmute, press ZONE2 or ZONE3 followed by MUTING
again. Zone can also be unmuted by adjusting the volume.
Advanced Operations