Supplied Accessories - Tascam PA-R200 Instruction Manual

For British models
Replacement and mounting of an AC plug on the power
supply cord of this unit should be performed only by
qualified service personnel.
IMPORTANT
The wires in the mains lead are coloured in accordance
with the following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the
terminal which is marked with the letter N or coloured
black.
The wire which is coloured brown must be connected to
the terminal which is marked with the letter L or coloured
red.
IMPORTANT
The plug is fitted with an appropriate fuse. If the fuse needs
to be replaced, the replacement fuse must approved by
ASTA or BSI to BS1362 and have the same ampere rating
as that indicated on the plug. Check for the ASTA mark or
the BSI mark on the body of the fuse.
If the power cord's plug is not suitable for your socket
outlets, cut it off and fit a suitable plug. Fit a suitable fuse
in the plug.

Supplied Accessories

Make sure you have the following accessories:
Indoor FM antenna (➔ page 18)
AM loop antenna (➔ page 18)
Power cord (➔ page 18)
Speaker cable labels (➔ page 12)
Speaker setup microphone (➔ page 34)
Remote controller (RC-PAR200) and two batteries
(AA/R6)
Rack-mounting kit
6 screws and 12 washers (two types × 6)
1 Bracket
* In catalogs and on packaging, the letter at the end of the product
name indicates the color. Specifications and operations are the
same regardless of color.
■
Installing the batteries
Batteries (AA/R6)
Note
• If the remote controller doesn't work reliably, try replacing the
batteries.
• Don't mix new and old batteries or different types of batteries.
• If you intend not to use the remote controller for a long time,
remove the batteries to prevent damage from leakage or
corrosion.
• Remove expired batteries as soon as possible to prevent damage
from leakage or corrosion.
• Be sure to insert the batteries with correct positive (+) and
negative (–) orientations.
En-4
Safety Information and Introduction
• If the batteries leak, wipe away the leakage inside the battery
compartment and replace the batteries with new ones.
• Do not heat or disassemble batteries.
• Do not carry or store batteries with other metallic objects. The
batteries could short circuit, leak or explode.
• Never recharge a battery unless it is confirmed to be a
rechargeable type.
■
Aiming the remote controller
To use the remote controller, point it at the AV receiver's
remote control sensor, as shown below.
Remote control sensor
■
RACK-MOUNTING THE UNIT
Use the supplied rack-mounting kit to mount the unit in a
standard 19-inch rack, as shown below.
Remove the feet of the unit before mounting.
Bracket
Caution
• Leave 1U of space above the unit for ventilation.
• Allow at least 10 cm (4 in) at the rear of the unit for ventilation.
AV receiver
Approx. 16 ft. (5 m)