Strong SRT 5406 User Manual page 26

You can search by channel number or by frequency (and restrict the search to broadcasts
within a particular bandwidth: 7 or 8 MHz).
4. To search for a channel by its number, select that number in the Channel No field.
5. To search for all channels broadcast on a particular frequency, press
Frequency field is highlighted and enter the frequency using the number keys on the remote
control.
6. To restrict the search to broadcasts within a particular bandwidth, press
Bandwidth field is highlighted and then press
shown.
TIP: To avoid a fruitless search, check the strength and quality of the signal beforehand.
These are shown by the Level and SNR bars at the bottom of the screen. Poor strength or
quality indicates that it may be difficult to scan for that channel or that the reception
might be too poor for you to comfortably watch the channel.
7. Press OK to begin scanning. When the search is finished, the channel will begin playing if it has
been found; otherwise the previous channel will reappear.
or until the bandwidth you want is
VOL VOL
26
or until the
CH CH
or until the
CH CH