Table of Contents
Advertisement
unless these parts or devices will be permanently
used in conjunction with the LRF device.
- Turn on the LRF.
- In the LRF menu select «SET», then «CAL». Press
ACTION.
- When the text «CALc» is shown, set the LRF
horizontally on a flat surface, where the LRF will be
rotated around vertical axis. Note: to achieve as
accurate calibration results as possible, the digital
compass should be exactly on the axis of rotation,
please refer to the illustration below showing the
location of the axis of rotation for this procedure.
- Press the ACTION. - -- Start rotating the LRF
module to perform one or two full rotations duration
1 min. The display will be blinking «CAL» during
entire process.
- When the display switches to «CALc», change
LRF position to be on the left side down. Note: to
achieve as accurate calibration results as possible,
the digital compass should be exactly on the axis of
rotation, please refer to the illustration below
showing the location of the axis of rotation for this
procedure.
22
Advertisement
Table of Contents
