O
VERVIEW
Registering Your Phone (continued)
9) Press F3 (OK) to confirm that you want to register this phone
and display the following:
• When registration has been successfully completed the LCD
displays the following:
• If the registration fails, the LCD displays the following:
• If registration fails, go back to Step 6.
10) Turn on (down) dip switch 1 re-enter the normal mode.
• After 30 seconds, the system goes back to normal mode.
• The LED on the base flashes normally when the unit enters
normal mode.
11) Remove, then replace the power from the base to re-power
the base on (i.e., reset the base).
>REGISTERING
PLEASE WAIT!
NOTE
Please be patient as the phone goes through the
registration process. It only takes a few moments.
>REGISTERING
HANDSET #1
TRY AGAIN!
NOTE
•
Up to two line cords can be used to connect two
digital station ports from the KSU to the two jacks
on the base.
•
If the handset ID is #1 this means the handset is
connected to Line #1.
•
If the handset ID is #2 this means the handset is
connected to line #2.
NOTE
If DIP switches are still set in the registration mode
(switch 1 off, switches 2 and 3 on), the unit is not
operational except for registration during the first 30
seconds when re-powering on the unit.
Registering Your Phone (continued on next page)
DX-80/120 Cordless Phone User Guide
>FAILED!
- 6 -